14SG Jlog and Powerbox GPS II

[jcflyer]

I am having trouble getting the gps II to register, I keep getting a (No Available Slots) message??? Can some one tell me the proper order of install? The jlog is installed and works perfect I just want to add the GPS II.....

jay

[rudi1025]

Soweit ich weiß ist PowerBox noch nicht in der T14SG eingebunden derzeit nur T18MZ.
oder steht in der Anleitung was anders.

lg
Rudi

[jcflyer]

Hi Rudi,
Thanks for replying, I am not sure what you mean by Powerbox not currently involved in the 14SG? Can you tell me more?

Jay

[rudi1025]

Hi Jay,

kommt beim nächsten Update der T14SG ist das drin.
siehe hier die Sensoren der T18MZ http://www.futaba-forum.net/basic/do...rte_V2.5.0.pdf

LG
RUDI

[jcflyer]

Rudi,
I am still not sure what you mean, this must be a communication thing between you and I. I have registered the powerbox in the 14SG already, as long as there are no other sensors already there. If I create a new model and register the gps II is shows up in my sensor screen as slots 16-23, if I try to register it in one of my models with the jlog sensor already in it; that's when it gives me the No Available Slots message. Because the jlog sensor uses 8 slots but not consectutively, they are spread out.

[rudi1025]

Hi Jay,

MODELL A: mit Jlog = OK ?
MODELL B: mit Powerbox = OK ?
MODELL C: mit Jlog + Powerbox = NOK ?
MODELL D: mit PowerBox + Jlog = NOK ?

Sender T14SG
Ich vermute das es ein Problem der Anmeldung ist.

Bitte die Funktionen ausfüllen lt. "Menü SENSOR"

Slot	Modell A	Modell B	Modell C	Modell D
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31

LG
RUDI

[jcflyer]

Rudi,
Good news I was finally able to get both the Powerbox GPS II and the Jlog sensors registered. I just had to register the GPS II first and then the Jlog, so now all sensors are registered and showing up in the telemetry screen and on the sensor screen also. Now just have to mount the GPS II on the heli and check it's operation!!!